Alex Are there any safety problems with school buses?
There are no aggregate statistical data to suggest that a safety problem exists in large school buses that the installation of lap belts would solve. In fact, there is growing concern among safety professionals around the world over the use of lap belts as a form of passenger restraint for young or small children.
Why is the school bus considered an extension of the classroom?
Pupil discipline is probably the most serious issue in pupil transportation. If the riders are misbehaving it takes the driver’s attention away from the driving responsibilities. The school bus is considered to be an extension of the classroom]
What was the watershed year for school bus safety?
The watershed year for school bus safety was 1977, when requirements for most of the important safety features were put into place. Tragically, it took a fatal school bus accident to accomplish a goal of further safety.
How many children were killed in school bus accidents?
According to a national annual survey done through the state directors of pupil transportation of each state, twenty-two children were killed in school bus loading or unloading accidents during the 1999–2000 school year, whereas eighteen were killed in the 1997–1998 school year.
What do you need to know about school bus safety?
The emergency door and emergency window must be designed to be opened from the inside and the outside of the bus and must be equipped with a fastening device that may be quickly released but is designed to offer protection against accidental release. The opening of the emergency door and window must not be controllable from the driver’s seat. 13.
Where is the emergency window on a school bus?
The emergency window in the rear must be equipped with a latch or latches on the inside connected with an electrical buzzer located in the driver’s compartment that will go off when the latch is being released. 10. Paneling 10.
What do you need for a school bus door lock?
The emergence door lock must be equipped with a suitable electric plunger type switch connected with a buzzer located in the driver’s compartment. The switch must be enclosed in a metal case, and the wires leading from the switch must be concealed in the bus body.
How does the buzzer work on a school bus?
The switch must be enclosed in a metal case, and the wires leading from the switch must be concealed in the bus body. The switch must be installed so that the plunger contacts the farthest edge of the slide bar so that any movement of the slide bar immediately closes the circuit on the switch and set off the buzzer.